Posts Tagged: guitar

CWS021 – Boost Preamp

Dual footswitch boost with tone bypass. The right switch acts as the master bypass for the effect, while the left switch adds in the tone control for an additional boost. This pedal is used by Vicente Elizondo as a preamp

CWS021 – Boost Preamp

Dual footswitch boost with tone bypass. The right switch acts as the master bypass for the effect, while the left switch adds in the tone control for an additional boost. This pedal is used by Vicente Elizondo as a preamp

CWS017-019

These three pedals were built as refinement to the concept in CWS016. The main circuit is the same as found in CWS008, with the addition of a switch that controls a large or small boost in the bass frequencies. The

CWS017-019

These three pedals were built as refinement to the concept in CWS016. The main circuit is the same as found in CWS008, with the addition of a switch that controls a large or small boost in the bass frequencies. The

CWS016

Boost pedal with modified tone section. The capacitors were selected from extended use with CWS008, to be the exact same circuit when the pedal was in its most utilized setting. From this starting point, CWS016 is able to reduce (or

CWS016

Boost pedal with modified tone section. The capacitors were selected from extended use with CWS008, to be the exact same circuit when the pedal was in its most utilized setting. From this starting point, CWS016 is able to reduce (or

CWS015 – Dual Momentary Footswitch

Two button footswitch with TRS jack. This pedal uses momentary switches to select up/down settings on a jamman loop pedal. It is a smaller version of the FS3X schematic with the exclusion of the mode switch. Here is the switcher

CWS015 – Dual Momentary Footswitch

Two button footswitch with TRS jack. This pedal uses momentary switches to select up/down settings on a jamman loop pedal. It is a smaller version of the FS3X schematic with the exclusion of the mode switch. Here is the switcher

CWS013 – Flute Filter Fuzz

This pedal has been in the works for a long time. I suppose the story starts years ago when I scavenged an old roadside Gulbransen organ, thrilled to find it overflowing with nice reusable poly caps, resistors, switches, pots, wire, and

CWS013 – Flute Filter Fuzz

This pedal has been in the works for a long time. I suppose the story starts years ago when I scavenged an old roadside Gulbransen organ, thrilled to find it overflowing with nice reusable poly caps, resistors, switches, pots, wire, and

Project 002 – Pedal board build

I have a habit of tearing apart and rearranging my pedal board for just about every tour that I go on. Earlier this year, I had switched the entire board over to a 6-channel true bypass strip and ran all

Project 002 – Pedal board build

I have a habit of tearing apart and rearranging my pedal board for just about every tour that I go on. Earlier this year, I had switched the entire board over to a 6-channel true bypass strip and ran all